Quick View

Technical Event

Water rocketry

Participant Type:

Individual Participant

Dept: Mechanical

Location:

Cricket ground

Timing:

26.04.2025 9:30 AM To 12 pm

Staff Coordinator:

Dr.A. Arun Negemiya

Student Coordinator - 1:

Mr.S.Sachin - III Mech - 9677688438

Student Coordinator - 2:

Mr.J.Tinf - III Mech - 9677688438

Description:

The participants are instructed to make their own rocket model and based on the range covered scores will be rewarded. Note: Stand will not be provided

Rules & Regulations:

Rockets must be built by the participating students using only the above listed materials
Only one two-liter bottle may be filled with water and pressurized
The pressurized bottle itself must not be modified structurally
Additions to the bottle (such as fins, nose cone, etc.) may be attached using ONLY tape
Paint or decorations on the plastic of the pressurized bottles are prohibited
Only tape, paper and plastic may be in direct contact with the pressurized bottle
Tape covering the bottle and other parts of the rocket may be painted or otherwise decorated
The mouth of the pressurized bottle must fit over a half-inch schedule 40 PVC pipe
Additional two-liter bottles may be cut and added to the pressurized bottle using only tape
Fins must not interfere with the mouth of the pressurized bottle so that it can fit on the launcher
Testing indicates that leaving a two-inch gap from the bottom of the fins to the plastic ring at the bottom of the mouth is enough distance to prevent interference

D'Mass SILVER ZONE

D'Mass GOLDEN ZONE

D'Mass DIAMOND ZONE